I have been asked to sell an Fp Miata I built for a customer(Andrew McCabe). He ran it once in 08 and it sat last year unused. He decided to get out of racing altogether. It was completely stripped to bare metal and painted inside and out. Build list below.
1) Integral FP3 cams
2) 10:1 Wiseco pistons
3) Prather oil pan baffle
4) Mazda Comp oil pump
As to what else is in the motor, I am not sure. It made 174 HP on a drum dyno.
5) TRE Inline tranny with spare ratios
6) 4.5" Quartermaster 2 disc clutch on button flywheel/flexplate
7) 4.78 Diff with RX7 plate type diff rebuilt
All hiem jointed tubular control arms similar to Yawpower
9) All brake sytem components are new from Mazda or Hawk
10) Both front and rear subframe are new from Mazda
11) New manual steering rack from Mazda
12) Electromotive TEC3r setup to run sequential fuel and spark
13) New 8 gallon Fuelsafe cell on pasenger floor
14) Full set of new Autometer gauges
15) Kirkey Intermediate RR seat(15")
16) 2 sets of Spinwerks wheels
17) Full Prather/AFCO shock package
When I assembled the car I was handed boxes of new Mazda hardware to use. It cost Andrew in excess of $45k to build. He is asking $25k
Chris at
5drew@comcast.net or 5084296717
